Warning: file_get_contents(/proc/loadavg): failed to open stream: Permission denied in /web/yannickf/www/spip/config/ecran_securite.php on line 303 [Modélisme, Électronique] : MPX2PPM
Je n’ai plus de stock. Utilisez les sources pour construire vous même le circuit.
For non-european customers : during RoyalEvo to RoyalPro upgrade, Multiplex USA didn’t change the back cover of your radio (Multiplex Europe did !!!). So you’ll probably have to manage some difficulties to close the (...)
Vous pouvez faire fabriquer mes circuits imprimés par BatchPCB. Aux USA, ils centralisent les commandes avant de sous-traiter en Chine. Les "panels" sont ainsi optimisés.
En cliquant ici, vous aurez accès à l’ensemble des circuits imprimés que j’ai pu (...)
Introduction :
This article is a english (very short) summary of the french version.
Since V3.30 firmware, RoyalPro7,9,12 and 16 won’t give you the necessary PPM signal for 3rd party 2.4 GHz modules (Assan/Corona/Spektrum etc...)
You can downgrade to V2.62 firmware, but you’ll loose memory (...)
Il y a une version française du manuel ici ... -
Normal mode (without BLDR jumper) :
Check that the TX and RX jumpers are connected. You must ensure that these 2 jumpers do not risk to remove by themselves, it would result in a crash of your RC model, since they are responsible of (...)
Informations are available on AVRUBD web site : http://avrubd.googlepages.com/stepbystep3.htm Start AVRUBD.exe Check COM port number in Windows Do not change other parameters Open new firmware .HEX file
Remove RX and TX jumpers (see picture at bottom), put the BLDR jumper and start the (...)